Skip to content
HomeSecurityCalc

APC BE600M1 UPS Battery Backup and Surge Protector Specifications

Quick answer

The APC BE600M1 UPS Battery Backup and Surge Protector is a battery backup for the recorder from APC listed at $79.99. Enough to carry a recorder, a PoE switch and the router through the short outages that make up most of them, which is when a camera system is most likely to be needed.

Published specifications
SpecificationValue
Rating 600 VA
Stated infrared range not published
Taken from the manufacturer listing. Rows marked as not published are figures this maker does not state, and this site will not estimate them.

What the manufacturer states

These are the maker's own listing bullets, kept as the citable source for the specifications above rather than paraphrased into claims we cannot attribute.

  • KEEP YOUR COMPUTER, WI-FI AND ROUTER RUNNING THROUGH POWER OUTAGES: Supplies short-term battery power during outages to maintain internet connectivity and allow safe shutdown of computer during power interruptions
  • POWER PROBLEMS DON'T ONLY HAPPEN DURING STORMS: 23 minutes of runtime (at 100W load) guards against outages, while surge protection shields connected devices from unexpected power events that happen even on a normal day
  • PROTECT EVERYTHING ON YOUR DESK: 5 well-spaced outlets with full battery backup and surge protection, plus 2 surge-only outlets for less critical gear
  • PHONE CHARGER: Keep your phone charged even when the power's out. The built-in 1.5A USB port works during outages

Others in battery backup for the recorder

Common questions


How far can the APC BE600M1 UPS Battery Backup and Surge Protector identify someone?

APC does not publish both a sensor resolution and a focal length for this product, and DORI distance cannot be derived without both. Rather than estimate one, this sheet leaves it out. If you have the manufacturer datasheet to hand, the DORI calculator on this site works the distance out from those two figures directly.

What is the infrared range of the APC BE600M1 UPS Battery Backup and Surge Protector?

APC does not publish an infrared range for this product, so this site does not state one. An invented figure would be worse than no figure, because a reader would plan a camera position around it. Where a maker does publish a range, treat it as the distance its own lamp reaches in ideal conditions rather than the distance at which a face stays identifiable.

What specifications does APC publish for this product?

Rating: 600 VA. Everything in the table on this page is taken from the manufacturer listing rather than measured by us. Any row shown as not published is a figure this maker does not state, and this site will not fill that gap with an estimate.

Is the APC BE600M1 UPS Battery Backup and Surge Protector worth buying?

Enough to carry a recorder, a PoE switch and the router through the short outages that make up most of them, which is when a camera system is most likely to be needed. This site does not test products in person, so that assessment comes from the published specifications, the applicable standards and verified owner reports rather than from hands-on trials we did not run. Prices change often, so check the current listing before deciding.

Get the system planning sheet

The camera count, storage and PoE budget worksheet, plus the wiring checklist, as one printable page.

No spam. Unsubscribe whenever you want.

Work out whether it fits

Specifications are published figures, not measurements we took. This site does not test products in person. Where a maker does not publish a figure, such as a true infrared range or a low light rating, this page says it is not published rather than estimating one, because a reader planning a camera position around an invented number is the worst outcome this site could produce.